30
EN
30
Self ignition function
The self ignition function can be used to receive images from the external unit cameras or from remote
cameras.
A self ignition command can be sent in 2 ways:
◊ Via the self ignition key: press the
L
key to send the command to the associated camera.
Contact your installer for key confi guration
◊ Via the self ignition menu: to use the function via the menu, proceed as follows:
Entrance Panels Directory
Name
Entrance 1
Entrance 2
Entrance 3
Entrance Panels Directory
Name
Entrance 1
Entrance 2
Ingresso 3
Actuators function
The actuators function is used to activate the relay output of an IO actuator module or that of an expansion
device connected to it.
Actuators Directory
Name
Actuator 1
Acuator 2
Acuator 3
Actuators Directory
Name
Actuator 1
Acuator 2
Attuatore 3
To Next Page
Loading...
