Comelit MT SB 01 - System Settings; Time, Date, and Language Configuration; Operating Mode and Speed Dial Setup

MT SB 01
MT SB 0135
E N
You can decide to organise the week by selecting
one of these three operating modes for each day:
• AUTO: the system passes from DAY mode to
NIGHT mode at the programmed times.
It is not possible to decide on different time bands for
days during which the system operates in AUTO mode.
• NIGHT: the system is in this mode for the whole
day.
• DAY: the system is in this mode for the whole day.
The system can be set to allow automatic passage
from DAY mode to NIGHT mode at specic times
which can be programmed by the user. A MAXIMUM
of 4 TIMES can be set.
It is extremely important to set the times for switching
from one mode to another correctly.
TIME 1: determines the rst mode switch: from
NIGHT mode to DAY mode
TIME 2: determines the second mode switch: from
DAY mode to NIGHT mode
TIME 3: determines the third mode switch: from
NIGHT mode to DAY mode
TIME 4: determines the fourth mode switch: from
DAY mode to NIGHT mode.
All 4 TIMES must always be set.
Example:
You want to congure the switchboard with the
following parameters:
07:00 - 12:00 Day mode operation
13:00 - 22:00 Day mode operation
TIME 1: 07:00 » NIGHT / DAY
TIME 2: 12:00 » DAY / NIGHT
TIME 3: 13:00 » NIGHT / DAY
TIME 4: 22:00 » DAY / NIGHT
- press the MENU key and use the keys to
view the 3-DAY/NIGHT AUTOMATIC menu, then
press 3;
3-DAY/NIGHT
AUTOMATIC
- press the 1-ON/OFF key to activate or deactivate
the function;
1-ON/OFF
2-SET TIMES
SERVICE
ACTIVE
SERVICE
NON ACTIVE
- press ESC to return to the main screen.
- press the MENU key and the 2-CHANGE DATE key;
1-CHANGE TIME
2-CHANGE DATE
- the cursor will be positioned on the rst digit. Enter the
date using the alphanumeric keypad, moving the cursor
using the keys;
SET DATE
00/00/00
- press OK to conrm;
- press until the desired day appears on the
display;
ENTER DAY:
MON
- press OK to conrm;
- press ESC to return to the main screen.
This section is aimed at qualied technicians who,
after installing the product, will program the porter
switchboard using guided menus, which can be
viewed on the display by navigating the main menu.
The user can apply these functions to change some
of the switchboard settings (e.g.: language, date/
time, delete all names in the directory, etc.).
Settings
- press the MENU key and the 1-CHANGE TIME
key:
1-CHANGE TIME
2-CHANGE DATE
- the cursor will be positioned on the rst digit. Enter
the time using the alphanumeric keypad, moving the
cursor using the keys;
SET TIME
00:00
- press OK to conrm;
- press ESC to return to the main screen.
I1 - Change time
I2 - Change date
I3 - Day/night automatic mode
I3.1 - Activation/deactivation