25
147 1,2,5,8 Self activation time: 60 sec (default)
149 1,3,5,8 Self activation time: 30 sec
237 1,3,4,6,7.8
Self activation: enabled
(default)
238 2,3,4,6,7.8 Self activation: disabled
154 2,4,5,8 System busy signalling time: 10 sec (default)
155 1,2,4,5,8 System busy signalling time: 300 sec
239 1,2,3,4,6,7,8
Confirmation tone on user call = enabled
(default)
240 5,6,7,8 Confirmation tone on user call = disabled
243 1,2,5,6,7.8 Reset wait time (after hang-up or after lock-release): 10 sec (default)
244 3,5,6,7,8 Reset wait time (after hang-up or after lock-release): 1 sec
208 5,7,8 Enables “Reset wait time" on lock-release command (default)
209 1,5,7,8
Disables “awaiting reset time" on lock-release command (awaiting response time or talk time will be
activated)
249 1,4,5,6,7.8
Send call: single
(default)
250 2,4,5,6,7.8 Call transmission: triple
Button tones
142 2,3,4,8
Button press tone ON
(default)
143 1,2,3,4,8 Button press tone OFF
Button backlighting management
158 2,3,4,5,8 OFF mode: Button LEDs always o
159 1,2,3,4,5.8 ON mode: Button LEDs always on
160 6.8 AUTO mode: Button LEDs on at night and o during the day, thanks to the twilight sensor (default)
161 1,6,8
Enables brightness control for the button LEDs.
f Press a button repeatedly for each module to change the individual brightness of the buttons
(see: “Adjusting the brightness of the button LEDs and the camera light”)
162 2,6,8 Light-me OFF (default)
163 1,2,6,8
Light-me ON: the button LEDs for the audio/video module are always on and when the button is
pressed all button LEDs light up (see: “Light-me function behaviour on the basis of the LED
backlighting mode”)
150 2,3,5,8 Light-me time: 30 sec
151 1,2,3,5,8 Light-me time: 60 sec (default)
152 4,5,8 Light-me time: 120 sec
Camera LED light management on self activation (only with Art. UT1020)
166 2,3,6,8 The LED light is always o upon self activation
167 1,2,3,6,8 The LED light copies the ON/OFF/AUTO mode set for calls (functions 168/169/170) (default)
Camera LED light management upon calls (only with Art. UT1020)
168 4,6,8 OFF mode: LED light always o upon calls
169 1,4,6,8 ON mode: LED light always on upon calls
170 2,4,6,8 AUTO mode: LED light on at night and o during the day, thanks to the twilight sensor (default)
171 1,2,4,6,8
Enables brightness control for the camera LED light.
f Press the programming confirmation button repeatedly to adjust the brightness
Restore backup
114 2,5,6,7
If the audio/video module is replaced, all programming is imported (only available if at least one
additional module is connected vi flat cable)
Reset
115 1,2,5,6,7
Reset button programming: if the modules are addressed (see “Address button modules”) this
resets the programming for the button call addresses
254 2,3,4,5,6,7,8
Reset special programming:
restore all the parameters described in this table to their default values
To Next Page
Loading...
