Installation and maintenance instructions
EN
3.4 DEMOLITION and DISPOSAL
When you intend to scrap the machine, drain the water from the tank and the boiler, as indicated in the previous
points, and disconnect the machine from the water and electric mains. Then dismantle the components
following that prescribed in the relevant standards in force in compliance with the national and local ecological-
environmental regulations, taking care to separate the parts as follows:
- metal parts: body, surfaces, panels, lters;
- electric parts: motors, contactors, microswitches, wires;
- plastic parts: ttings, dish racks;
- rubber parts: hoses, sleeves.
3.5 SCHEDULED MAINTENANCE
It is recommended to have the machine serviced every 6 MONTHS.
37
To Next Page
Loading...
Need help?
General
