For stainless steel, laser engraving can be done directly on its surface. For specific engraving
parameters, please refer to the table of recommended engraving parameters; For other metals,
such as iron, aluminum and copper, they cannot be carved directly. They can be carved only
after a layer of coating is attached to the surface of the material.
Whether engraving can be done on metal surfaces?
Q16
For a low-power laser with a wavelength of 450nm, metal can not be cut.
Whether metal can be engraved?
Q17
(1) The normal service life of the laser module is 10000 hours. In the actual test, the optical
power will decay after using 8000 hours. There will be a certain impact on the cutting, so we
recommend that the laser head needs to be replaced after using 10000 hours;
(2) Regularly maintain the laser head and clean the stains on the surface lens/enclosure.
The service life of the laser module.
Q18
Please execute the preview command before engraving, it will move at the boundary of the
engraving area in the form of weak light. If this boundary is beyond your engraving range, you
can move the object or move the laser position to adjust it.
How to ensure that the laser engraving pattern is within the
envisaged range?
Q19
09
(1) For the laser module, its normal service life is more than 10000H. Of course, the use environ-
ment will also have a certain impact on the service life and engraving ability. When the laser
module lens is found to be scorched yellow or the lens is blurred, it needs to be properly
cleaned;
(2) Regularly check the fit tightness of the pulley and the profile;
(3) Regularly check whether the belt is notched. In the installation or other processes, do not
bend the belt. The belt is equipped with steel wire, bending is likely to lead to wire fracture.
Whether the machine needs maintenance?
Q15
To Next Page
Loading...
