(1) Check whether the laser focal length is correctly adjusted. 5W laser focal length is 23mm
and 10W laser focal length is 45mm;
(2) We recommend that you refer to the recommended engraving parameters in the manual
for setting;
(3) If the laser lens is obscured by foreign objects, we recommend you to clean the lens regu-
larly;
(4) Confirm whether the software settings are wrong (for Lightburn);
(5) When it is cutting, we recommend that the cutting materials do not have a lot of deforma-
tion. If there is, we recommend that you first press together flat after cutting;
(6) The cutting speed is not recommended to be lower than 120mm. If it is for thicker materials,
we suggest you to cut twice or more times in a separate way. If the speed is too slow, it will
easily lead to serious burning around the cutting edge of the board.
Engraving or cutting does not achieve the desired effect.
Q5
04
To Next Page
Loading...
