Commodore 1581 - Vectored Jump Table

JIRQ
JNMI
JBLOCK
$FF03
$FF06
JVERDIR
JINTDRV
JPART
JMEM
$FF09
$FF0C
$FF0F
$FF12
$FF15
JUSER
JRECORD
JUTLODR
JDSKCPY
JRENAME
JSCRTCH
JNEW
ERROR
JATNSRV
JTALK
JLISTEN
JLCC
JTRANSTS
CMDERR
JSTROBE
CONTROLLER
JCBMBOOT
JCBMBOOTRTN
JSIGNATURE
JDEJAVU
JSPINOUT
JALLOCBUFF
$FF18
$FF1B
$FF1E
$FF21
$FF24
$FF27
$FF2A
$FF2D
$FF30
$FF33
$FF36
$FF39
IFF3C
$EF3F
$FF54
$FF57
$FF5A
$FF5D
$FF60
$FF63
$FF66
Interrupt routine. Interrupts normally occur
from the following sources — ATN line going
low, Fast Serial Byte is shifted in, timer time
out, execution of a BRK instruction.
Does a 'soft' reset (UI command). Default vec
tors and variables are restored. Searches for
"COPYRIGHT CBM 86" USR type file to boot.
No RAM check or ROM checksum is done. De
vice # switches are read.
VALIDATE command (collect).
INITIALIZE command.
Routine to create or switch partitions.
Memory Read/Memory Write (M-R,M-W) com
mands.
Performs all BLOCK commands, such as ALLO
CATE, FREE, READ, WRITE, EXECUTE, POINT
ER
USER command.
RECORD command for relative file positioning.
Utility loader command (&).
Copy command.
Rename command.
Scratch command.
New/Format command.
Controller error handler routine.
Serial Bus attention (ATN) server.
Serial Bus talk routine.
Serial Bus listen routine.
Controller routine.
Logical to physical sector translation routine.
DOS error handler routine.
Direct Controller call.
CBM autoloader routine.
Return from CBM autoloader with autoloader
disabled.
Signature analysis routine.
Switch for autoloader boot on INITIALIZE or
BURST INQUIRE/QUERY. Enter with carry, set
to enable autoloader, carry to clear disable it.
SPIN, SPOUT. Sets up.fast serial direction as
input or output. Carry set to do SPOUT, cleared
to do SPINP.
Allocates RAM buffers. Call with buffer # in reg
A(l = buffer 0,2 = buffer 1...).
109