Commodore 1581 - Page 18

1. Turn on system.
2. Insert diskette.
3. If you are using a VIC 20, Commodore 64, or a Commodore 128
computer in C64 mode, type: LOAD "HOW TO USE",8
If you are using a Plus/4 or Commodore 128 in C128 mode, type:
DLOAD "HOW TO USE"
4. Press the RETURN key.
5. The following will then appear on the screen:
SEARCHING FOR 0:HOW TO USE
LOADING
READY
I
6. Type: RUN
7. Press the RETURN key.
To load a different program or file, simply substitute its name in
place of HOW TO USE inside the quotation marks.
-NOTE
The HOW TO USE program is the key to the Test/
Demo diskette. When you LOAD and RUN it, it provides
instructions for using the rest of the programs on the dis
kette. To find out what programs are on your Test/Demo
diskette, refer to the section entitled "DIRECTORIES" later
in this chapter.
If a program doesn't load or run properly using the above meth
od, it may be that it is a machine language program. But unless you'll
be doing advanced programming, you need not know anything about
machine language. A program's user's guide should tell you if it is
written in machine language. If it is, or if you are having trouble
loading a particular program, simply add a ;1 (comma and number 1)
at the end of the command.