I
[~
[~
[-
[~
[.-
[:
Do
not
specify filename{s)
Command format: DISKCOPY d:
d:[/1]
[Diskcopy)
•
You
specified
an
incorrect switch or gave a
filename
in
addi-
tion
to a drive name.
DOS
2.0
or
later required
[Attrib )[8ackup
)[FC)[
Graphics )Uoin )[Mode )[Restore )[Subst)
• You
cannot
use these utilities with
i.xx
versions
of
MS-DOS.
Do
you see the leftmost
O?
(YIN)
[Mode)
• Mode displays this message to
help
you
align the test pattern
on
your
screen.
Type
Y
(for
Yes)
if
you
can
see
the
leftmost 0 in
the
test pat-
tern,
or
type N
(for
No)
if
you
want
to
shift
the
display
to
the
right.
Do
you see the rightmost 9?
(YIN)
[Mode)
• Mode displays this message to help
you
align the test pattern
on
your
screen.
Type
Y ( for Yes)
if
you
can
see
the
rightmost 9 in
the
test pat-
tern,
or
type N
(for
No)
if
you
want
to
shift
the
display
to
the
left.
Drive letter must be specified
[Format)
• You
did
not
specify the drive letter
for
the drive that
you
want
to
format
You
must
specify
the
name
of
the
drive that
you
want
to
for-
mat.
Drive x: not ready
Make sure a diskette is inserted into
the drive and the
~oor
is closed
[Diskcomp )[Diskcopy)
• The drive is empty,
or
you
did
not
close the door
of
the disk
drive.
Drive types
or
diskette types
not
compatible
[Diskcomp )[Diskcopy)
• You
must
have the
same
size
and
type
of
disks to
run
these
commands. For example,
you
cannot
copy
from
a single-sided
disk to a double-sided disk,
or
compare a high-density disk
with
a low-density
disk
0281
To Next Page
Loading...
