Commodore PC 10 - Page 420

1282 Appendix E MS-DOS Message Directory
E
You should use Fe if you want to compare the files on the
disks. If you want to copy the disk, you can use copy or xcopy,
or reformat the target disk so that it's the same type as the
source disk, or use a disk of the same type.
Duplicate file name
[Rename)
• You tried to rename afile to afilename that already exists, or
the name you specified could not be found.
ECHO is off (or on)
[MS.DOS]
• This message tells you the current status of Echo.
End of input file
[Edlin]
• The entire file was read into memory. If the file was read in
sections, this message indicates that the last section of the file
is in memory.
Enter current Volume Label for drive x:
[Format)
• Format asks you to enter the current volume label for verifica·
tion before it formats the hard disk in the specified drive.
If you do not know what the volume label is, press CONTROL·C
to abort this command, and give the vol command for the
specified drive. Then give the fonnat command again.
Enter new date:
[Date)
• You must respond to this prompt when you start MS·DOS, or
when you use the Date command.
Enter the date in a mm-dd-yy format, or press the RETURN key
to accept the current date.
Enter new time:
[Time]
• You must respond to this prompt when you start MS·DOS.
Enter the time in the hh:mm format, or press the RETURN key
to accept the current time.
Entry error
[Edlin]
• The last command you typed contained a syntax error.
Retype the command with the correct syntax and press the
RETURN key.
c: