Commodore PC 10 - Page 429

Insert SOURCE diskette into drive x:
[Diskcopy]
• This message prompts you to put the disk to be copied into the
specified drive.
Insert system diskette in drive x:
and strike any key when ready
[Sys]
• Sys needs a disk from which to read the io.sys and msdos.sys
files.
Insert a system disk into the specified drive and press any char-
acter or number key to start the system copy process.
Insert TARGET diskette into drive x:
[Diskcopy]
• Diskcopy displays this message to prompt you to place the
target disk
into the specified drive. If your computer has one
floppy drive, this message prompts you to put the proper disk
into the drive.
Insufficient disk space
[ MS-DOS ][ Replace ][ Sort ][Xcopy ]
• The disk is full and does not contain enough room to perform
the specified operation.
Insufficient memory
[Backup ][ Chkdsk][ Diskcomp ][Diskcopy ][ Edlin ][ Replace]
[Restore
][ Sort ][ Xcopy ]
• There is not enough memory in your computer to perform the
specified operation.
Before retrying this operation, you must free memory by delet-
ing files. In
edlin, you may be able to free memory by typing a
W
(write) command followed by an A (append) command.
Insufficient memory for system transfer
[Format]
• Your memory configuration is insufficient to transfer the
MS-DOS system files io.sys and msdos.sys with the Format /s
switch.
Insufficient room in root directory.
Erase files
in root and repeat CHKDSK
[Chkdsk]
• Chkdsk always recovers lost files into the root directory.
In this case, your root directory is full
Delete some files in your root directory, or move them to
another directory to make room for the lost files.
12911