Commodore PC 10 - Page 430

1292 Appendix E MS-DOS Message Directory
Intermediate file error during pipe
[MS-DOS]
• The pipe operation uses temporary files on the disk that are
deleted
automatically once the piping process is complete_ An
error has occurred in one Of these files-
Make sure that there is enough room on the disk for the tem-
porary file and that
the disk is not write-protected, and try the
command again_
Internal error
[FC][Mode ](Share]
• This message indicates an error in the utility_
Invalid argument
[Backup ]( FC]( Restore]
• You have specified an invalid argument.
Refer to Chapter 3, "MS-DOS Commands," for the correct syntax
of the command, and try again_
Invalid baud rate specified
[Mode]
• You have specified an incorrect baud rate_ Valid choices are
110, 150, 300, 600, 1200, 2400, 4800, and 9600_
You must specify at least the first two digits of the baud rate_
Invalid characters in volume label
[Format]( Label]
• The volume label should only contain up to 11 alphanumeric
characters_
Invalid COMMAND.COM
Insert
COMMAND. COM disk in default drive
and strike any key when ready
[MS-DOS]
• The program you have just run used up almost all of memory_
MS-DOS must now reload the command_com file from disk
However, either MS-DOS cannot find command_com on the disk,
or the copy found is the incorrect version.
Insert a disk that contains a copy of command com into the
default drive (it must be the same version with which you
started MS-DOS)_
Invalid country code
[MS-DOS]
• In your config_sys file you have specified a country number
that is not in the table of files configured in this version of
MS-DOS_ country codes must be in the range 1-99 and are set
by your computer manufacturer.