ADCP-90-545 • Issue 4 • July 2016
Page 18
© 2016 CommScope. All Rights Reserved.
2. Align the tabs on the 6pak plate with the notches in the mounting slot.
3. Slide the 6pak or blank up into the slot until
it snaps in place.
4. If installing pigtails, route the fibers within
the chassis corresponding to Figure 14 and
Figure 15 for the 12-fiber and 24-fiber termination/splicing panel, respecti
vely.
Figure 14. Pigtail Routing in 12-Fiber Termination/Splicing Panel
Figure 15. Pigtail Routing in 24-Fiber Termination/Splicing Panel
To Next Page
Loading...