CommScope FL1000 - 1 Unpacking and Inspection

ADCP-90-545 • Issue 4 • July 2016
Page 2
© 2016 CommScope. All Rights Reserved.
This manual contains all procedures required to install and operate any FL1000 product or product
option. The procedures are presented in the order in which they would normally be done, with
separate installation sections for rack-mount and wall-mount units. Select from the procedures based
on your specific installation.
Revision History
ISSUE DATE REASON FOR CHANGE
Issue 1 09/1998 Original.
Issue 2 04/2001 Non-technical update.
Issue 3 08/2011 Revised for new two-door design for wallbox.
Issue 4 July 2016 Reformatted for CommScope.
Trademark Information
FL1000 is a registered trademark of CommScope. Inc.
ST is a registered trademark of AT&T Technologies, Inc.
Admonishments
Important safety admonishments are used throughout this manual to warn of possible hazards to
persons or equipment. The admonishments — in the form of Dangers, Warnings, and Cautions
— must be followed at all times.
Danger: Danger is used to indicate the presence of a hazard that will cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Warning: Warning is used to indicate the presence of a hazard that can cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Caution: Caution is used to indicate the presence of a hazard that will or can cause minor
personal injury or property damage if the hazard is not avoided.
1 UNPACKING AND INSPECTION
Unpack and inspect the various components as follows:
1. Inspect the exterior of the shipping container(s) for evidence of rough handling that may
ha
ve damaged the components in the container.
2. Unpack each container while carefully checking the conte
nts for damage.
3. File a claim with the commercial carrier and notify BCG Technical Assistance Center, if
damage is detected
or if parts are missing. Save damaged cartons for inspection by the carrier.
4. Save all shipping containers for use if the equipment requires
shipment at a future date.