P/N 29010017 V1.0 - 65-
11. The rudder doesn't always move even
though the Port or Starboard output LED is lit
on the autopilot front panel.
The autopilot is using a CT1T Type 1 Control
Box, either as part of a CP1H Hydraulic Pumpset,
or a CP1L Hydraulic Linear Actuator, or with an
existing reversing electric drive system.
a) Recheck all the connections between the
autopilot and the control box, making sure that
none are reversed.
b) Remove the cover of the CT1T Type 1
Control Box and check the setting of the
minimum speed potentiometer for too low a
minimum speed.
To Next Page
Loading...
