INS_CNGE2+2SMS_REV– 02/19/13 PAGE 42
INSTALLATION AND OPERATION MANUAL CNGE2+2SMS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Port Guardian – CLI Reset
The Port Guardian feature can be cleared from the USB serial port connection on the unit through
the CLI and also the port status can be displayed to show any ports that are in lock out state.
To access the Port Guardian CLI commands connect to the CLI using the procedure described in the
Command Line Interface Management section on page 48 and then use the commands described
below.
Command Description
portguardian show Will display any ports that are currently in port lockout fault state.
Command Description
portguardian clear Will clear any ports that were previously in port lockout fault state.
To Next Page
Loading...
