Compaq Presario 5000 Series - Page 88

United States
STORE | PRODUCTS | SERVICES | SUPPORT | CONTACT US | SEARCH
Compaq Presario Internet PC 5000 Series Computers
Removal and Replacement Procedures
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT
PROCEDURES
JUMPER AND SWITCH
INFORMATION
SPECIFICATIONS
Electrostatic
Discharge
Service
Considerations
Preparation for
Disassembly
Serial Number
Side Access Panel
Graphics Card
Expansion Card
(Modem or Network
Card)
1394 Card
Memory Module
Hard Drive
Disk Drive
Removing the Top
Door
Removing the CD
Storage Door
(Lower Front Panel -
Open the CD Storage
Door)
Optical and Mass
Replacing the Microprocessor/Heatsink Assembly, Continued
Replacement
Remove and discard the
plastic film on the bottom of
the new thermal pad.
3.
Place the new thermal pad
(plastic pad side up) onto the
heatsink in the same position
as the old thermal pad.
4.
With the round portion of the
screwdriver handle, rub the
top of the new thermal pad
to ensure that the entire pad
sticks to the heatsink.
5.
Carefully remove and discard
the plastic tab on top of the
new thermal pad.
6.
Next Step