Compaq Presario 5700 Series - Page 107

Option Card Retainer
Graphics Board
Fax/Modem
Networking Interface Card
Memory
Processor
Processor Retention Clips
RTC Battery
System Board Cables
System Board
Parallel Port
Back I/O Panel
Power Supply
4. Remove the
Graphics Board
(on selected
models only).
5.
Remove the
Fax/Modem.
6. Remove
Networking
Interface Card
(on select
models only).
7.
Remove
Memory.
8. Remove the
Processor.
9. Remove the
Processor
Retention Clips.
10. Disconnect the
System Board
Cables.
11. Remove nine
screws from the
System Board.
12. Slide System
Board toward
drive bay
and lift from the
computer.
Replacement
To replace the
system board,
reverse the
removal
procedure.
Compaq.com - Compaq Presario Maintenance and Service Guide - 5700 Series
http://www.compaq.com/athome/support/msgs/5700/rmsysbd.html (2 of 3) [1/10/2002 11:55:51 AM]