Maintenance and Service Guide
Compaq Presario EZ2000 Series Computers
Product Description Troubleshooting Illustrated Parts Catalog
Home Removal & Replacement Jumper & Switch Information Specifications
Models and
Features
Digital
Dashboard
CPU Controls
and Lights
Right Easy
Access Panel
Left Easy
Access Panel
USB
Keyboard
Controls
Rear CPU
Connectors
Power Cord
Set
Requirements
PRODUCT DESCRIPTION
Power Cord Set Requirements
The power cord set (flexible cord and wall plug) received with the computer meets the
requirements for use in the country where the computer was purchased.
Power cord sets for use in other countries must meet the requirements of the country where you
use the computer. For more information on power cord set requirements, contact your Compaq
authorized dealer, reseller, or service provider.
General Requirements
The requirements listed below are applicable to all countries:
1
The length of the power cord set must be at least 6.00 feet (1.8 m) and
a maximum of 9.75 feet (3.0 m).
2
All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power cord
set will be used.
3
The power cord set must have a minimum current capacity of 10A and a
nominal voltage rating of 125 or 250 volts AC, as required by each
country's power system.
4
The appliance coupler must meet the mechanical configuration of an EN
60 320/IEC 320 Standard Sheet C13 connector, for mating with
appliance inlet on the Switch Box.
To Next Page
Loading...
