Maintenance and Service Guide
Compaq Presario EZ2000 Series Computers
Product Description Troubleshooting Illustrated Parts Catalog
Home Removal & Replacement Jumper & Switch Information Specifications
DISASSEMBLY
SEQUENCE
Electrostatic
Discharge
Service
Considerations
Preparation
for
Disassembly
Serial Number
Left Easy
Access Panel
Right Easy
Access Panel
Memory
Module
Top Access
Panel
REMOVAL & REPLACEMENT
Service Considerations
Tool Requirements
Phillips screwdriver
■
Needle-nose pliers■
Flathead screwdriver■
Compaq Utilities software■
Screws
The screws used in these products are not interchangeable. If an incorrect screw is used during the
reassembly process, it could cause damage to the unit. Compaq strongly recommends that all screws
removed during the disassembly process be kept with the part that was removed, then returned to
their proper locations.
IMPORTANT: As each subassembly is removed from the computer, it should
be placed away from the work area to prevent damage.
Cables and Connectors
Most cables used throughout the unit are ribbon cables. These must be handled with extreme care to
avoid damage. Apply only the tension required to seat or unseat the cables during insertion or removal
from the connector. Handle cables by the connector whenever possible. In all cases, avoid bending,
twisting, or tearing the cables, and ensure that they are placed in such a way that they cannot be
caught or snagged by parts being removed or replaced.
To Next Page
Loading...
