• In order to enter the programming mode, press the “SET” button
and hold it down and press the “PROG” button, too. During the
programming the values being adjusted are ashing on the
display. The modication of these values can always be done
using the large and buttons. The conrmation of a
value is always done by pressing the “PROG” button, after which the
next value can be adjusted. The program can be saved by pressing
the “SET” button. A more detailed description of the programming
steps can be found in Section 4.3.
• If there are days, for which the same program is needed, than it is
sufcient to create that program only once, since it can be easily
copied to another day using the “COPY” button as described in
Section 4.4. If the same program is needed for every day, then there
is also a possibility to create the program of all the days together (by
selecting MON TUE WED THU FRI SAT SUN together during the
21
To Next Page
Loading...
