4.5 Modifying the program
• The previously set program can be modied any time by repeat-
ing the steps of programming.
• The number of activated switches can be increased at will as
described in Section 4.3.
• A previously activated switch can be deactivated by setting its
start time to using the large and buttons (or by
pressing the “DAY” button once), and then pressing the “PROG”
button. After this, if the deactivated switch was an intermediate
one, then the serial numbers of the remaining switches will be
updated.
• If you wish to nish modifying the program of the selected day,
then press the “PROG” button and hold it down for at least 3 sec-
31
To Next Page
Loading...
