Computherm Q7 - Program Inspection

4.6 Program inspection
• First, press the “SET” button to go to the main screen, then press
the “PROG” button. At this point, the abbreviation indicating the
day(s), the symbol of switch PROG and the time and temperature
level set for switch PROG of the selected day(s) will appear on the
display (none of the values is ashing).
• Repeatedly press the “PROG” button to check the values of switch
PROG , PROG , etc. Use the large and buttons to
change the day(s). If all the days were programmed together (MON
TUE WED THU FRI SAT SUN), then their common program can
only be viewed together.
• After checking the program, press the “SET” button to go back to
the main screen (if no buttons are pressed for at least 15 seconds,
the thermostat will automatically go back to the main screen).
33