MODEL 2200
www.comtecltd.com For Kasco Corp use only.
5
5. Turn thumb screw on the right side of the travel plate clockwise to lock the
lower die half in position.
6. Insert pocket of upper die half into hub at heater assembly. Using the supplied
hex head wrench, turn wrench to secure die. The hex head wrench fits into the
opening located in the panel on top of Press. The die must be “snug” but not
overly tight to assure good heat conduction. (See Figure 4)
Figure 4 Installing Upper Die Half
7. Switch Power On.
8. USING TWO HANDS, ONE HAND ON EACH LEVER, push both levers
down simultaneously to bring the travel plate up. Check to see if the dies close
fully. When the dies close fully, the damming ring on the upper die half will move
1/8 inch (3 mm) or more. If the dies do not close fully, bring the travel plate down
Figure 3 Installing Lower Die Half
To Next Page
Loading...