MNC-0500-026 21 of 32 Revision G
Amplifier Communication and Protocol, Rabbit CPU
Miscellaneous Set Up continued. . .
Query: PEI?
Returns: PEI192.168.1.10 where 192.168.1.10 is the IP Address of the
Amplifier.
Query: PHX<?>
H = Heater
X = parameter you wish to query -- V for heater voltage, I for heater current.
Query: PHV?
Returns: PHVnn.n where nn.n is the measured heater voltage in volts.
Query: PHI?
Returns PHInn.n where nn.n is the measured heater current in milliamps.
Query: PKn<?>
K = Firmware checksum.
1 = Test Firmware checjsum.
2 = Calculate and return Firmware checksum.
Examples:
Query: PK1?
Retnrns: PKs where s is a string: “OK” or “FAIL” (note white space around
strings.)
Query: PK2?
Returns: PKxxx, where xxx = 8 bit checksum value (0-255)
Query: PX?
X = Transmit Power-up state
Returns: PXn where n is the power ON state: 0 = NORMAL (the last state
before Power OFF); 1 = OFF (Power-up into Standby mode); 2 = ON (Power
-up into Transmit mode).
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
To Next Page
Loading...