Need help?Do you have a question about the Comtrol DEVICE MASTER RTS and is the answer not in the manual?
Explains how to navigate and use the interactive Table of Contents.
Describes the DeviceMaster RTS and links to installation procedures for models.
Procedure for installing the RTS 1-Port device.
Procedure for installing the RTS 4 or RTS 8 devices.
Procedure for installing the RTS 16 with external power.
Procedure for installing the RTS 16/32RM with internal power.
Steps to add another DeviceMaster RTS to an existing configuration.
Procedure to replace an existing RTS with another unit.
Lists the default IP address, subnet mask, and gateway.
Details the procedure for configuring the RTS unit's IP address.
Explains how to use MAC addressing for RTS communication.
Provides links and instructions for obtaining NS-Link drivers and documentation.
Procedure to connect asynchronous serial devices to RTS ports.
Guides on building custom null-modem and straight-through serial cables.
Pinout and wiring for constructing RS-232 null-modem cables.
Pinout and wiring for constructing RS-422 null-modem cables.
Pinout and wiring for constructing RS-232/485 straight-through cables.
Pinout information for DB9 serial port connectors on the RTS.
Instructions for building DB9 female loopback plugs for testing.
Pinout information for RJ45 serial port connectors on the RTS.
Instructions for building RJ45 serial port loopback plugs.
Instructions for building an RS-485 test cable.
Lists electromagnetic compliance standards the RTS family adheres to.
Details specifications for external power supplies for RTS models.
Explains FCC regulations regarding radio frequency interference.
Details FCC labeling requirements for the device.
Discusses user authority regarding equipment modifications.
Certification details for serial cables used with the device.
States that the equipment is Underwriters Laboratory "UL" listed.
Provides critical safety warnings for handling electrical equipment.
A checklist to help diagnose common problems with the RTS device.
Outlines the basic steps for installing the RTS 1-Port Embedded system.
Detailed instructions for building a DB9 serial ribbon cable for the RTS.
General| Manufacturer | Comtrol |
|---|---|
| Model | DEVICE MASTER RTS |
| Category | Server |
| Connectivity | Wired |
| Power Supply | External AC adapter |
To Next Page
