Need help?Do you have a question about the Conair Thermolator TW-2 and is the answer not in the manual?
General| Brand | Conair |
|---|---|
| Model | Thermolator TW-2 |
| Category | Control Unit |
| Language | English |
Highlights critical safety warnings and precautions to prevent injury.
Defines the Thermolator TW Series and its purpose in temperature control.
Explains the operational principles of Direct Injection models.
Details the operational principles of Closed Circuit models.
Describes the operational principles of Isolated Circuit models.
Covers site requirements, clearances, and power source preparation.
Guides on properly connecting fluid and water lines to the unit.
Explains the procedure for safely connecting the unit to electrical power.
Outlines steps to verify the functionality of the TW control after installation.
Details the testing procedure for TW-1 and TW-2 control installations.
Guides through the initial configuration and parameter settings for TW control.
Covers initial setup and dip switch configuration for TW-1/TW-2 controls.
Guides on setting high/low deviation limits for alarms.
Step-by-step guide on powering up and initiating operation of TW units.
Procedure for safely shutting down the Thermolator unit.
Guides on starting operation for TW-1 and TW-2 models.
Instructions for safely stopping TW-1 and TW-2 units.
Instructions for optimizing control performance through auto-tuning.
Steps for performing auto-tune on TW-1 and TW-2 units.
Provides a recommended schedule for routine checks and upkeep.
Guides on interpreting alarms and error codes for TW units.
Explains how to diagnose issues for TW-1/TW-2 units using alarms.
Lists common alarms, their possible causes, and solutions for TW units.
Details alarms that cause the unit to automatically shut down.
Covers alarms that indicate a potential issue without immediate shutdown.
Lists system error codes indicating non-recoverable microprocessor issues.
Troubleshooting steps for units that do not receive power or light up.
To Next Page
