Concept2 SkiErg User Guide

14
0712
MISCELLANEOUS
•Cleaning the PM
Useaclothlightlydampenedwithwateronly.Donotspraywithacleanerorleaveintherain.
•Formulas Used
Watts=2.80/(sec/meter)^3
Calories/Hour=Kcal/hr=(watts)x(4)x(0.8604)+300
Do not:
• Opentheplasticcase
• Dropthebatterypack
• Allowbatterypackpinstotoucheach
other or any metal object
• Useifdamagedorleaking
• Trash,incinerate,crush,etc.
Do:
• UseonlyinaPM4;ifnotusedinPM4,storecarefullysopinsarenotshorted
• Keepcleananddry
• Usebetween0˚and40˚C
• Charge(skiorplugPM4intoUSB)afterprolongedperiodofnon-use
• Keepbatterypackawayfromchildren
• Recycleproperly
 WARNING:Ifbatteriesleak,donotusethem.Batteryuidsarecorrosiveandcandamageeyes,irritateskin,etc.If
contact occurs, wash affected area immediately and thoroughly with water.
Safety Information for PM4 Rechargeable Battery Pack
Portfortheoptional
Polar™heartrate
receiver.
Bottom View of PM
Battery cover
PM3
Race system jacks
PM4
Back View of PM
Reset here
Flywheel sensor cable must be connected
hereforthePMtooperate.
USBportforconnectingto a computer. Beveled
cornersonUSBcableplugfacethebackofthe
monitor. DO NOT FORCE when plugging in.
See concept2.com/pm for current information.
PM TROUBLESHOOTING
1. IfthePMmalfunctionsordoesnot“wakeup,”resetPM:
• Insertapen/penciltipintotheresetholeonthebackandpresslightly.
• Removethebatteriesfor30minutesandinserttwonewalkalineD-Cell(LR20)batteries.
2. To change language: press MENU/BACKuntilscreenstopschanging.Pressfthgreybuttononright,thenpresssecond
grey button on right twice, and select your language. Alternately, hold down CHANGE UNITS and CHANGE DISPLAY
andresetmonitor.Youcanthenselectyourdesiredlanguage.(Note: ThisprocedurewillresetPMtofactorysettings.)
3. IfyourcomputerdoesnotrecognizethatyourPM3/PM4isconnectedtoittryoneofthefollowing:
• Useanothercomputerand/orUSBcable.
• RemovebatteriesandUSBcablefor30minutesthenreinsertbatteriesandtryagain.
Refer to concept2.com/pm for more information and software updates.
Battery compartment: Loosen screw and press
thumbstrike in direction shown to open.
PM3
PM4
Notes:
1)RemovebatteriesorbatterypackfromthePM3orPM4if
monitor will not be used for a period of four months or more.

Concept2 SkiErg Specifications

General

Resistance Type	Air resistance
Monitor	PM5
Drive Mechanism	High-strength cords
Power Requirements	2 D cell batteries
Maximum User Weight	227 kg (500 lb)
Construction	Steel and aluminum
Storage	Can be stored upright
Display Metrics	Time, distance, pace, calories, watts, stroke rate
Space Recommended for Use	61 cm x 122 cm (24 in x 48 in)
Warranty	2-year limited warranty