EasyManuals Logo

Concept2 SkiErg User Guide

Concept2 SkiErg
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
0712
A minimal amount of maintenance performed on a regular basis will assure proper function and
prolongthelifeofyourSkiErg.ThePMwillkeeptrackofaccumulated,orlifetime,meters.Thiswill
helpyoudeterminewhentoperformmaintenanceprocedures.ToviewlifetimemetersonthePM
pushMainMenu/MoreOptions/Utilities/ProductID/MoreInformation.
On a Regular Basis
Untwist the Cords
As you grasp the handles to use your SkiErg, you may be inadvertently twisting the cords, much
like what would happen to the cord on a telephone hand set. Over time, this may cause the cords
to twist around each other inside the SkiErg resulting in a “lumpy” feeling when you pull on the
handles. This may cause premature wear of the cord.
To avoid this, we encourage you to check the cords regularly and untwist them as needed. You’ll
be able to see the twist in the cord; simply untwist by turning the handle in the opposite direction
to the twist.
Follow this procedure periodically to fully untwist the cords. This is easiest done with two people.
1.Pulloutbothhandlesasfarastheygo.
2. Hold the cords at the top bracket allowing the handles to dangle and spin freely.
3. Run your hand down the length of each cord to untwist the cord.
4. Return the handles to the top position.
5. Repeat the process starting at step #1 at least two times.
Clean Grips and Straps
Useamildsoaporcleaningproducttocleanthegripsandstrapseveryfewworkoutsasneeded.
Every 500,000 meters (approximately 50 hours of use)
Inspect the Cords
There are three separate cords and one bungee cord to inspect.
Important! Each cord is of a specific type and should be replaced with the appropriate Concept2
replacement cord if significant wear or damage is observed. See page 16 for a description of cord
wear/damage.
Cord Inspection:
1. The handle cord is a single cord connected to both handles and can be easily inspected
by pulling the handles all the way out and visually checking for wear. See page 16 for a
description of cord wear.
MAINTENANCE

Other manuals for Concept2 SkiErg

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Concept2 SkiErg and is the answer not in the manual?

Concept2 SkiErg Specifications

General IconGeneral
Resistance TypeAir resistance
MonitorPM5
Drive MechanismHigh-strength cords
Power Requirements2 D cell batteries
Maximum User Weight227 kg (500 lb)
ConstructionSteel and aluminum
StorageCan be stored upright
Display MetricsTime, distance, pace, calories, watts, stroke rate
Space Recommended for Use61 cm x 122 cm (24 in x 48 in)
Warranty2-year limited warranty

Related product manuals