Contax S2 - Lens Mounting and Removal; Mounting the Lens; Removing the Lens

<Mounting the lens>
Remove the
rear lens and
body caps
by turning
them
counter-clockwise,
then align the
red
dot
on the camera
body mount
with the red dot on the lens
mount.
Insert
the
lens into the body of
the
camera
as
far
as
it
will then turn the
lens clockwise until
it locks in
place
with
a click.
<Removing
the lens>
To remove the lens,
grasp
both
the camera
body
and
the
lens firmly. Next,
press
the
lens
release
button and
turn the
lens
counter-clockwise as
far as
it will
go,
and
remove
the
lens from
the
camera.
IMPORTANT: After
removing
the
lens,
be sure that the
rear
cap
on the lens
and the
body cap
are replaced.
Both
the
lens
and camera can be
easily damaged if dust
is allowed to
get
inside.
.
Also, when mounting
or
removing
the lens,
be
careful notto touch
the
mount
portion
of the
lens
or
the inside
of the camera
with
your
fingers.
.
When mounting
or
removing
a
lens with
film loaded
in
the camera, avoid direct
sunlight.