To Next Page

To Previous Page

Telehealth medical diagnostic system IDIS2GO

to the【Data Management】interface. If “No” is selected, it will return directly to the【Data Management】

interface.

Picture 17: Delete data interface

d) Denote value

In the 【Data Management】 interface select “Denote value” to enter 【Denote value】, as shown in the

Picture 18. Select one option to determine the value of the notation, after which it will automatically return to the

interface 【Data Management】.

Picture 18: Value denoting interface

e) Exit

In the 【Data management】interface select “Exit” to return to the【Menu】interface.

3. Settings

In the 【Menu】 interface, select “Settings” to enter the 【Settings】 interface, as shown in the Picture 19.

Under this interface can be set language, Bluetooth on / off, time and calibration, as well as viewing device

information.

Picture 19: Settings menu Picture 20: Language settings menu

a) Language settings

In the【Settings】interface select “Language” to enter the【Language settings】interface, as shown in the

Picture 20. Select “English”, the language of the device will be English, select “中文”, the language of the device

will be Chinese, after selection we will automatically return to the【Settings】interface.

b) Bluetooth

Move the selection bar to “Bluetooth”, press the “Confirm” button to select “ON” or “OFF”, here the

Bluetooth module can be turned on or off (if the device does not have a Bluetooth module, the operation will not be

active).

c) Time settings

In the【Settings】interface select “Time” to enter the【Time settings】interface, as shown in the Picture 21.

Select “Minute” to enter the【Minute setting】interface, as shown in the Picture 22. Press the Up or Down buttons

to change the value (long press available), then press the Confirm button to return to the【Time settings】interface.

Operations “Hour”, “Day”, “Month”, “Year” are similar to “Minute”. The “week” will be calculated according

to the “Year”, “Month” and “Day”; it does not need to be set manually. Then select “Exit” to return to the【

Settings】interface.

Contec SP10W User Manual

Questions and Answers: