Graph Settings - Static Scaling
Static Scaling imposes fixed criteria that the EMG/Spatial signal must satisfy in
order to be counted as a Switch. These criteria remain unchanged over time.
Signal On Amplitude:
Sets the EMG/Spatial
amplitude the signal must
cross above in order to be
counted as a Switch.
Signal Off Amplitude:
Sets the EMG/Spatial
amplitude a signal
counted as a Switch must
fall below before a new
Switch can be counted.
Setting this parameter at
the same level as the
Signal On Amplitude will
remove Signal Off
Amplitude as a Switching
determiner.
PAGE 22 | ACCESSORIES
To Next Page
Loading...