12
In more detail...
CLIND2BK-C Induction Hob
GB
IE
Preparation before use
• Read carefully these instructions before starting operation. Pay particular
attention to the section related to a safe use (→ Safety).
• When the power is switched on, an acousitc signal indicates that the
induction hob has entered the state of standby mode. All the indicators show
"
--" or "-".
• Remove any protective lm that may still be on your ceramic hob.
• Clean the surface (→ Cleaning and maintenance).
General operation
• The controls respond to touch,
so you don’t need to apply any
pressure.
• Use the ball of your nger, not its
tip.
• You will hear a beep each time a
touch is registered.
• Make sure the controls are always clean, dry, and that there is no object
(e.g. a utensil or a cloth) covering them. Even a thin lm of water may make
the controls difcult to operate.
Warning!
Always lift pans off the induction hob.
Do not slide the cookware on the hob surface, as this may damage
the induction hob.
Operation
To Next Page
Loading...
Need help?
General
