Cooper Security 9750 - Operator Controls and Displays

To Next Page

To Previous Page

4 496478

1. Introduction

Operator Controls and Displays - 9925

Figure 3. 9925 Arming Station.

The 9925 arming station is intended for use solely in setting and unsetting the

system. The 9925 has the following LEDs:

a Glows steadily when mains power is present. Flashes when the

system is working from battery backup.

s Glows steadily if:

a) A PA, Fire, 24 hour or tamper circuit is active while the system is

unset.

b) The system needs an engineer or remote reset.

c) A telephone line fault is present.

S Glows steadily when the system is set. Note that you can program the

system to extinguish the S lamp three minutes after the system sets

(see Command 28 in "4. Programming").

y Glows when the system is ready to set.

The 9925 has the same number keys as the LCD keypad. However the 9925

does not have the A and B Level setting keys, and uses ✱ and # in place of X

and y .

Cooper Security 9750 - Operator Controls and Displays - 9925