4. Programming
496478 45
“Installer Mode”. The system sets its internal clock/calendar to the time
you have given it.
Abort Reset (Command 53)
Option 0 ensures that reset after abort is the same as system reset (see
Command 33).
Option 1 enables customer reset after an abort if they unset the system
within 90 seconds of the alarm.
Level B Final Exit Response (Command 60)
Command 60 controls how the system will treat Final Exit zones in Part Set
Level B. When the command option is set to 0 any Final Exit zones included
in Part Set B will continue to act as Final Exit zones during Part Set B. When
the option is set to 1 any Final Exit zones included in the Part Set B will act
as Normal Alarm zones while the system is Part Set.
Level B Entry Route Response (Command 61)
Command 61 controls how the system treats Entry Route zones during Part
Set B. When the option is set to 0 all Entry Route zones included in Part Set
B will continue to act as Entry Routes during Part Set B. When the option is
set to 1 any Entry Route zones included in the Part Set B will act as Final Exit
zones while the system is Part Set.
Level B Exit Mode (Command 62)
Command 62 specifies the exit mode for Level B.
Option 0 makes the keypad sounders and any internal sounders give a
low tone when entering Part Set Level B. Use command 65 to select the
exit time.
Option 1 makes the Part Set B Instant Set (no exit tone)
Option 2 makes the Part Set B Silent Set. Use command 65 to program
the Exit time.
Level B Alarm Response (Command 63)
Command 63 specifies the alarm response for Part Set B.
Option 0: Keypad sounders only
Option 1: Internal sounders and keypad sounders
Option 2: Local alarm (internal and external sounder only)
Option 3: Full alarm (communication and internal/external sounders).
Level B Entry Time (Command 64)
This command sets the entry time for Level B. See “Programming Com-
mands” for options.
To Next Page
Loading...