Cooper Security M800

To Next Page

To Previous Page

7 Configure Wards

8 Edit Groups

9 Log

6. Press ] twice to exit.

Option 2-4-4:

Programming

Telecommands

Use this option to allocate telecommand or

PA buttons to individual wards.

Cooper Security Limited recommend that

you take advice from your alarm installer

before modifying any of these options.

User 2 Menu 4

Edit Codes

1. Press [ to select this option.

User Codes 4

Telecommands

2. Use | or ¬ or press 4 to select

Telecommands then press [.

2:01:1 RNode

Telecmd 1

3. Select the telecommand or PA by using

| or ¬, then press [.

At this point you can press a

telecommand or PA button to make its

details appear on the display. Press [

to proceed to step 4.

>Telecmd Type

Global

4. Use | or ¬ to select an option (see

steps 5 to 9 below).

Telecmd Type

>Global

5. Press [ to select this option.

Use | or ¬ to select either:

Global: The telecommand can set or

unset any ward allocated to its buttons,

anywhere on site (depending on radio

range and conditions). A PA can start

an alarm in its allocated ward,

anywhere on site. OR:

Cooper Security M800 - Page 30