Cooper Scantronic 9 5 Series User Manual

4. System Configurations
497096, Issue 6 Page 85
Note: There are three new output types (commands 81-84) that you can use to indicate
the status of the system: Alarm Confirm, Set Complete and Unset Complete.
Alarm Filtering
The alarm system should either:
a) Have the means to indicate to the Alarm Receiving Centre (ARC) whether
the alarm system is set or unset (open and close signals).
or
b) Be capable of generating a secondary signal identifiable at the ARC as a
mis-operation signal (see Command 36 Alarm Abort).

Cooper Scantronic 9 5 Series Specifications

General

Brand	Cooper
Model	Scantronic 9 5 Series
Category	Control Unit
Language	English