KIT Base Unit ED175 Installation Instructions
© 2016, Cornelius Inc. - 3 - Publication Number: 629097525INS
INSTRUCTIONS
Disconnect Electrical power and turn off primary regulator on CO2 tank in Back-Room Package (or where
applicable, if located in other area).
NOTE: To convert BASE UNIT ED175 PLR to RENEW OR SHOTS, use this manual only.
LOOSE SHIPPED PARTS
• Sensor bracket assembly
• Door switch bracket assembly
• 1/8" Rivets
TOOLS REQUIRED
• #2 Phillips screwdrivers (stubby, standard and long)
• Pop rivet gun or equivalent for 1/8 rivets
• Pliers – adjustable, Wire cutters
• 7/16"Socket driver/wrench (for shots units only)
• Standard flat screwdriver
To Next Page
Loading...
