Rear-Facing Mode
2423
Adjusting Tether Strap
To tighten: After the car seat is
locked into place with the lower
anchor belt or vehicle belt, push
down on the car seat and gently pull
on the free end of the tether strap.
To loosen: Lift up on the tether
adjuster and push it towards the
tether hook.
Pull Free End of
Belt to Tighten
Lift Adjuster Up to
Loosen
Storing Tether Strap
When installing in the Rear-Facing
Mode or when the car seat is not
installed in a vehicle, attach the
tether hook to its storage attachment
on the back of the car seat as shown.
Gently tighten to remove slack.
Adjuster
Strap
Hook
Storage
Attachment
Tether Storage
and Parts
Never install a rear-facing child restraint in the
front seat of a vehicle equipped with an active
frontal airbag.
Do not use the tether for rear-facing mode. Secure the
tether strap hook to its storage attachment.
Do not use the lower anchor belt along with the vehicle lap
or lap/shoulder belt.
Check the vehicle belt or the lower anchor belt before each
use. Use only if the belt can be tightened properly and
locked securely in place.
Do not fasten multiple lower anchor hooks on the same
lower anchor bar in the vehicle.
This child restraint must always face the rear of the
vehicle until the child is at least 1 year old and weighs
22 lb (10 kg).
Lap/Shoulder
Belt
Lap Belt LATCH: Lower
Anchor Belt
5-40 lb (2.3-18 kg) and 19-40 in. (48-101.6 cm)
To Next Page
Loading...
