continued on next page
26
Vehicle Belt Install
25
1
2
3
4
Place Car Seat Rear-Facing
in Back Seat
Check if Your Vehicle Belts Will
Work With This Car Seat
This is very important because not
all vehicle belts will work with car
seats.
Review pages 18-21 and your
vehicle owner’s manual to fi nd out
what kind of vehicle belts you have
and how to lock a car seat in place.
Check Rear-Facing Level Lines
For children who weigh between
5-22 lb (2.3-10 kg), the bottom
level line must be parallel with the
ground.
For children who weigh between
22-40 lb (10.1-18 kg) and can sit
up unassisted, rotate the car seat
between the 2 level lines.
Start by making the bottom level line
parallel with the ground, then roate
the car seat up.
Do not rotate past the top level line.
Locate Rear-Facing Belt Path
Before you begin installing the car seat
into your vehicle, did you check:
Your child’s weight and height?
5-40 lb (2.3-18 kg) and
19-40 in. (48-101.6 cm)
Your child’s fi t? See page 6.
Do you need to make adjustments to the
harness strap position or the buckle position?
Route Vehicle Belt
Thread the vehicle belt through the
Rear-Facing Belt Path opening as
shown. The belt goes:
• across the car seat; AND
• under the car seat pad; AND
• in front of the buckle; AND
• out the other Rear-Facing Belt
Path opening.
Do not twist belt.
5
To Next Page
Loading...
