EasyManua.ls Logo

Cosco APT 50 - Preparing Car Seat for Child Fit; Rear-Facing Child Fit Guidelines; Head Position; Harness Strap Position

Cosco APT 50
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
2
6
Preparing Car Seat for Child Fit
5
Fully Loosen Harness Straps
Push down on the harness release
lever (through the opening in the
pad) while pulling out on the harness
straps as shown.
Unbuckle Harness
Press in towards the top of the
red button and pull out the buckle
tongues.
Release Chest Clip
Hold each side of the chest clip.
Press on the release button with your
thumb and pull the chest clip apart.
1
4
Place Child in Car Seat
to Determine Proper
Harness Fit
Your child’s bottom and back should
be fl at against the car seat.
2
Buckle
Tongue
3
For Rear-Facing Child Fit, see page 6.
For Forward-Facing Child Fit, see page 7.
Rear-Facing Child Fit
Need to make adjustments?
To change harness strap position, see page 8-9.
To change buckle position, see pages 10-11.
Harness Strap Position
The harness strap must be at or
slightly below your child’s shoulders;
never above.
Buckle Position
The buckle must be used in either
the 1st or 2nd buckle slot.
Choose the slot closest to your child.
The buckle should not be
underneath or behind your child.
Head Position
The top of your child’s head must be
at least 1 in. (2.5 cm) below the top
of the car seat.
Do not use 3rd slot in
Rear-Facing Mode.
Release
Button

Other manuals for Cosco APT 50

Related product manuals