Cosco APT 50 - Changing Harness Strap Position; Changing Buckle Position

sewn
end
continued on next page
Changing Buckle Position
109
Unbuckle Harness
Press in towards the top of the
red button and pull out the buckle
tongues.
Turn Car Seat Over
Locate the buckle’s metal retainer
on the bottom of the shell.
From Top of Car Seat, Pull
Buckle Out of Shell and Pad
Insert Buckle’s Metal Retainer
into Buckle Slot Closest to
Child
The buckle must face out.
Rear-Facing Mode: You must use
the 1st or 2nd buckle slot.
Forward-Facing Mode: Any slot can
be used.
Check your child’s fit often.
If you cannot achieve a snug harness fit for your child,
see pages 12-15.
To learn how to check harness tightness, see pages 44-46.
Check the harness straps often for any wear or damage.
1
2
3
5 1
2
3
4
Buckle
Tongue
From Back of Car Seat,
Attach 1st Harness Strap
Loops to Splitter Plate As
Shown
The sewn ends of the harness strap
loops must face towards you.
Do not twist the harness strap or the
harness adjustment strap.
Make sure the harness strap loops
are fitted completely on both sides
of the splitter plate.