1211
Check your child’s fit often.
If you cannot achieve a snug harness fit for your child,
see pages 12-15.
To learn how to check harness tightness, see pages 44-46.
From Bottom of Car Seat, Pull
Metal Retainer Completely
Through Pad and Shell
Check Buckle
Pull up on the buckle to make sure it
is secured.
The buckle must not pull out.
5
6
Failure to place buckle’s metal retainer completely
through pad and shell can result in serious injury or death.
Harness System Adjustments
for Smaller Infants
If you cannot achieve a snug harness fi t for your child,
you may need to adjust the buckle strap and/or the
harness strap length as shown in this section.
With Buckle in 1st Slot,
Turn Car Seat Over
If you need to move the buckle to
the 1st slot, see pages 10-11.
Pull Up Front of Car Seat Pad
Pull Buckle’s Metal Retainer
Towards You, Then Push It up
into Middle Buckle Slot As
Shown
2
1
3
Adjusting Buckle Strap Length
continued on next page
To Next Page
Loading...
