23
ELECTRICAL CONNECTION
IMPORTANT:
• Before installation or servicing, disconnect the power supply by either
removing the fuse, shutting off the main power or manually "tripping" the
circuit breaker.
• Installation work and repairs should only be performed by a qualified
technician in accordance with all applicable codes and standards.
Repairs and service by unqualified persons could be dangerous and the
manufacturer will not be held responsible.
• Before connecting the appliance to the power supply, make sure that the
voltage and frequency listed on the rating label correspond with the
household electrical supply. This data must correspond to prevent
appliance damage. Consult an electrician if in doubt.
• Connect the cooktop cable to the junction box through the UL listed or
CSA approved conduit connector.
• When making the wire connections, use the entire length of conduit
provided. The conduit must not be shortened.
The cooktop must connect to a single-phase (split-phase), 3-wire or 4-wire,
AC 240 Volt 60 hertz electrical system. This appliance must be supplied with
the proper voltage and frequency, and connected to an individual, properly
grounded, 50 amp (minimum) branch circuit protected by a circuit breaker or
time-delay fuse.
ELECTRICAL SHOCK HAZARD
• Disconnect power before servicing.
• Use 8 gauge copper wire.
• Electrically ground cooktop.
• Failure to follow these instructions can result in death, fire, or electrical
shock.
WARNING
To Next Page
Loading...
Need help?
General
