Cosmo COS-ERC365KBD - Troubleshooting; Cooktop Problems

53
TROUBLESHOOTING
Fi
rst try the solutions suggested here to possibly avoid the cost of a service
call.
COOKTOP PROBLEMS
PROBLEM POSSIBLE CAUSE SOLUTION
Surface units
do not turn
on
There is no power
to the range.
Make sure electrical plug is
plugged into a live, properly
grounded outlet. Replace the fuse
or reset the circuit breaker.
Cooktop controls
improperly set.
Check to see the correct control is
set for the surface unit you are
using.
Excessive
heat around
cookware on
cooktop
The cookware is
not the proper
size for the
element or
burner.
Use cookware with a bottom
surface approximately the same
size as the cooking area, element,
or surface burner. Cookware
should not extend more than 1"
(2.5 cm) outside the cooking area.
Adjust the power level or burner
flame appropriately.
Frequent
cycling on
and off of
surface units
The element
cycle on and off
to maintain the
heat setting.
This is normal even when the
element is on the highest setting.
Surface unit
stops glowing
when
changed to a
lower setting
The unit is still on
and hot.
This is normal.
Cooking
results are
not what
expected
Using incorrect
cookware.
See "Using the Proper Cookware"
in the "Operation" section.
The control knob
is not set to the
proper heat level.
See "Using the Cooktop Elements"
in the "Operation" section.