Coxo C-SMART-1 Pro - M1 Apex Locator Only (Without Motor); Working

C-SMART- l Pro Uaar Manual
8.2 Sound Volume and Screen Brightness Adjustment
r::7' NOTE
C-SMART·lPro Uoar Manual
8.2.1Sound Volume Adjustment
The sound volume can be adjusted to 4 different levels: high. low, Minimum
and limited off_
• Press the key 4 [._Ill,>] in the idle state to adjust the sound volume;
• The sound volume display on the LCD panel status area.
r::7' NOTE
The last sound volume is retained, even if the power is turned off.
8.2.2 Screen Brightnes s Adjustment
The Screen Brightness can be adjusted to 4 different levels.
• Press the key 5 [•·:+:·] in the idle state to adjust the screen brightness;
• The Screen Brightness display on the LCD panel Status area.
r::7' NOTE
The last Screen Brightness Is retained, even If the power Is turned off.
8.3 Operation
The device can be operated in three different modes:
CDM1 apex locator only;
M2 Motoronly;
@M3 as a combined unit (Dual mode)when the apex location function
drives the endo-motor.
One of the three possible operating modes is selected with the MODE key
6 i•oo;l.on the operating panel, the mode number display on the LCD panel
Mode area.
8.3. 1 M1 Apex locator only{wlthout motor)
8.3.1.1 Connection
The connection method in this mode is shown in chapter 7.3.5 (Fig.6).
When turning off the LED lighting function, the LED delay time function
can't be selected.
Motor option area shows the state of LED lighting:
P!l Means LED lighting function is not available;
P!iil Means lighting function is available and the delay time is 3S.
8.3.2.8 Working
Start and stop the Motor handpiece
·The motor is started and stopped with the ON/OFF key on the handpiece.
•If you press the ON/OFF key briefly, the motor handpiece starts.If you
re-press the key, its tops.
Manual Reverse
·Press the on I off button for more than 2 seconds to change the direction of file
rotation (whether the motor is stopped or running).
The current direction of file rotation is displayed in the motor option area:
Means forward rotation
Means reverse rotation
r::7' NOTE
Only continuous rotary file systems can change the direction; reciprocating
flle systems can not change the direction.
Torque bar
When the motor handpiece starts and its load reaches approximately half of
the preset torque limit value, the torque bar display••••• ,when the load
approaches the torque limit value. the torque bar display ••••• 11 .
r::7' NOTE
This function Is only available In continuous rotary file system.