17
The HDD should be installed inside the DVR.
Connect the HDD in according to the instructions,
screwing the HDD into the HDD brackets or DVR
base. All necessary cables are included with the DVR.
If using a hard drive from another manufacturer, use
instructions that came with the hard drive for specific
details on proper wiring and installation. Connect the
power cable to the appropriate socket, and connect
the data cables to their corresponding ports.
For a list of HDDs tested and approved for
compatibility with LB Tech DVRs, see Appendix 2
.
3.5.3 PTZ Control Connections- (optional)
Connect the PTZ (point, tilt, and zoom) control jacks to the corresponding RS485 A and B
interfaces on the rear panel.
·
For a detailed description of PTZ protocols, baud rates and IDs, refer to the
se
To Next Page
Loading...
