50
5.7.1 PTZ Channel
This is the channel that PTZ is connected to.
5.7.2 PTZ Protocol
From this field, select the PTZ device protocol. It must be consistent with the protocol of the
actual PTZ cameras installed. There are two available options: Pelco-D and Pelco-P. The
changes will take effect after clicking “
” to save the changes and exiting the menu.
5.7.3 PTZ Baud Rate
Select the PTZ device baud rate. It must be consistent with the baud rate of the actual PTZ
cameras installed. This system supports four options: 1200, 2400, 4800 and 9600. The changes
will take effect after clicking “
” to save the changes and exiting the menu.
5.7.4 PTZ Data Bit
The options for the PTZ Data Bit are “5”, “6”, “7” and “8”. The default setting is “8”.
5.7.5 PTZ Stop Bit
The PTZ Stop Bit options are “1” and “2”. The default setting is “1.”
5.7.6 PTZ Parity
The PTZ parity options are: “None”, “Odd”, “Even”, “Mark” and “Space”. The default setting
is “None.”
5.7.7 PTZ Address
In this field, select the PTZ device ID. It must be consistent with the ID of the actual PTZ
cameras installed. Choose any number from 1 to 255, but note that this is not the same as the
number of the channel to which the PTZ camera is connected in the DVR system. The changes
will take effect after clicking “
” to save the changes and exiting the menu
Note that the abovementioned channel setting must match the settings of the PTZ camera.
6. Web Browser Operation
6.1 Feature
Install the software through the Internet browser of OS to conveniently operate the network
from a remote location. This DVR supports C/S, B/S, and access in LAN and WAN. It also
supports IP and domain name visiting.
IMPORTANT! SOFTWARE RECOMMENDATIONS：
Note: When making changes to PTZ camera functionality /
settings, make sure that these changes are being made to actual
PTZ cameras by selecting the correct number in the previous
field (Camera Channel).
To Next Page
Loading...
