59
select ”Device Alarm” to enter the “Device Alarm” setup interface. From this interface, users
can set alarm event types; that is, they can decide which types of events will trigger an alarm by
selecting event types from the “Event Type” dropdown menu. They can also turn the buzzer
and alarm out on or off from this page.
Channel alarm settings: From the sidebar on the left, click “Alarm Setting,” then select
“Channel Alarm” to enter the “Channel Alarm” setup interface. From this interface, users can
set I/O alarms for each channel, set motion-detection alarms, define motion-detection privacy
masking areas, motion sensitivity, alarm-out time, buzzer time, prerecording time, and
post-recording time.
D. PTZ Settings
To Next Page
Loading...
