7.1.3 General Settings
• Enabled: Select/deselect to
enable/disable.
• Force NAT: Normally the LAN
Route Mode controls the use of
NAT (network address
translation). When this option is
selected the router will always
perform NAT when traffic is
sent out from this device.
• Priority: This number controls
failover and failback order. The
lower the number, the higher
the priority and the more use
the device will get. This number
will change when you move
devices around with the priority
arrows in the WAN Interfaces
list.
• Load Balance: Select to allow
this device to be available for
the Load Balance pool.
• Download bandwidth: Defines the default download bandwidth for use in Load Balance algorithms. (Range: 128 Kb/s to
76800 Kb/s.)
• MTU: Maximum transmission unit. This is the size of the largest protocol data unit that the device can pass. (Range: 46 to
1500 Bytes.)
To Next Page
Loading...
